2004 Arctic Cat ATVs factory service and repair manual, Page 240Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 240

3Lubricate the inside wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder
the piston on the connecting rod making sure there is circlip on each side and the open end of the circlip faces upwardsINOTE:
The piston should be installed so the arrow points towards the front 4Loosely install the two nuts with washers which secure
the cylinder to the right-side crankcase halfINOTE: The two cylinder-to-crankcase nuts will be tightened in step 9 2Place
the two alignment pins into positionPlace the cylinder gasket into position; then place piston holder (or suitable substitute)