2004 Arctic Cat ATVs factory service and repair manual, Page 241Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 241

5While keeping tension on the cam chain, place the front cam chain guide into the cylinder A CAUTION Care should be taken
the chain ca it! 8Install the two lower nuts securing the cylinder head to the cylinder, one in front and one in rear Keep
tension on the cam chain to avoid damaging the crankcase boss 9In crisscross pattern, tighten the four cylinder head cap
screws to 3.8 kg-m (27.5 ft-lb)Tighten the two lower cylinder head nuts to 2.5 kg-m (18 ft-lb) and the cylinder-to-crankcase
nuts to 1.1 kg-m (8 ft-lb) 10With the timing inspection plug removed and the cam chain held tight, rotate the crankshaft
until the piston is at top-dead-center 11With the alignment pin installed in the camshaft, loosely place the cam sprocket