2004 Arctic Cat ATVs factory service and repair manual, Page 242Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 242

14With the alignment pin installed in the camshaft and the cam lobes directed down (toward the piston), place the camshaft
to 1.5 kg-m (11 ft-lb)INOTE: Place the tab washer on the sprocket making sure it covers the pin the alignment hole 13Place
the C-ring into position in its groove in the cylinder head Camshaft Alignment Hole I NOTE: Note the position of the alignment
marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf rotating the camshaft is necessary
for alignment, do not allow the chain and sprocket to rotate and be sure the cam lobes end up in the down position INOTE:
At this point, oil the camshaft bearings, cam lobes, and the three seating journals on the cylinder 16When the camshaft assembly