2004 Arctic Cat ATVs factory service and repair manual, Page 252Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 252

Top-Side Components I NOTE: For efficiency, it is preferable to remove and disassemble only those components which need to
timing inspection plug; then using the recoil starter, rotate the crankshaft to top-dead-center of the compression stroke
37Remove the torx-head screws securing the left-side clutch plenum to the engine; then remove the plenum and account for
gasket 1Remove the two tappet covers 38Remove the engine from the right side by moving the engine forward while raising the
engine in the rear and rotating the engine counterclockwiseThe engine will come out the right side of the frame I NOTE: Keep
the mounting hardware with the covers for assembly purposes or thread them back into the head to keep them separated Remove
the 12 cap screws securing the valve cover to the head; account for the four rubber washers on the top side cap screwsRemove