2004 Arctic Cat ATVs factory service and repair manual, Page 257Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 257

Removing Left-Side Components ARecoil Starter BWater Pump CCover DRotorFlywheel 1Remove the four cap screws securing the
pump; then remove the crossover tube from the cylinder headAccount for an O-ring Remove the flange nut securing the starter
cup to the crankshaft; then remove the starter cupAccount for the O-ring inside the cupUsing cold chisel, scribe mark showing
the relative position of the shift arm to the shift arm shaft to aid in installing; then remove the shift arm 6Remove the
two cap screws securing the water pump to the engine; then remove the water pump c AT THIS POINT To service the water pump,