2004 Arctic Cat ATVs factory service and repair manual, Page 258Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 258

8Using Side Case Puller (pln 0644-262), remove the side coverAccount for gasket and two alignment pinsINOTE: Inspect the
gears for installing purposes; then remove the two starter gear shafts 9Remove the nut securing the magneto rotor to the
crankshaft; then install the magneto rotor puller adapterI NOTE: The puller has left-hand threads 10.Using Magneto Rotor
Remover Set (pln 0444-075), remove the rotorlflywheel assembly from the crankshaftAccount for the key; then remove the starter
clutch gear assembly and washer 12Remove the snap ring securing the water pump driven gear; then remove the gear noting the