2004 Arctic Cat ATVs factory service and repair manual, Page 269Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 269

Measuring Valve GuideNalve Stem Deflection (Wobble Method) 1Mount dial indicator and base on the surface plate; then place
way down into each valve guide bore; then remove the gauge and measure it with micrometer2Acceptable inside diameter range
must be within specifications3If valve guide is out of tolerance, it must be replaced 3To install valve guide, use valve
guide installer and gently drive valve guide with retaining clip into the bore from the valve spring side until the retaining
clip just contacts the cylinder head Replacing Valve Guide INOTE: If valve guide is worn or damaged, it must be replaced
1If valve guide needs replacing, insert valve guide remover into the valve seat side of the valve guideUsing hammer, gently