2004 Arctic Cat ATVs factory service and repair manual, Page 278Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 278

Cleaning and Inspecting I NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
the rope out of the handle; then untie the knot in the rope and remove the handleI NOTE: Do not remove the spiral spring
unless replacement is necessaryIt should be visually inspected in place to save timeIf replacement is necessary, follow steps
9-10 Remove the spring from the case by lifting the spring end up and out,thel remainder of the spring with thumbs and alternately
release each thumb to allow the spring to gradually release from the caseUnwind the rope from the reel and remove the rope
2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope counterclockwise around the reel
leaving approximately 50 cm (20 in of rope free ofthe reel3Apply low-temeraturegrease to the spring and hub 4Thread the end
of the rope through the guide hole of the case; then thread the rope through the handle and secure it with double knotInstall