2004 Arctic Cat ATVs factory service and repair manual, Page 286Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 286

3.Acceptable gap specifications range Measuring Connecting Rod (Big End Width) 1Using calipers, measure the width of the
indicator3Maximum deflection specificationsmust not exceed Measuring Connecting Rod (Big End Side-to-Side) 1Push the lower
end of the connecting rod to one side of the crankshaft journal2Using feeler gauge, measure the gap between the connecting
rod and crankshaft journal 3Zero the indicator and rotate the crankshaft slowly should be taken to support the connecting
rotating the crankshaft 4Maximum mnout must not exceed specificationsI NOTE: Proceed to check runout on the other end of
the crankshaft by positioning the indicator contact at point and following steps 2-4 Measuring Crankshaft (Web-to-Web) 1Using
calipers, measure the distance from the outside edge of one web to the outside edge of the other web Page: 286 Arctic Cat