2004 Arctic Cat ATVs factory service and repair manual, Page 291Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 291

4Using plastic mallet, lightly tap the case halves together until cap screws can be installed5From the right side, install
only until snugI NOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 9In crisscrosscase-to-case
pattern, tighten the mm cap screws until the halves are correctly joined; then tighten to 2-2.4 kg-m (14.5-17 ft-lb) 3Using
propane torch, heat the right-side crankshaft bearing until the oil begins to smoke; then join the two crankcase halves INOTE:
Rotate the shafts back and forth to ensure no binding or sticking occurs 10In crisscrosscase-to-case pattern, tighten the
mm cap screws to 0.9-1.3 kg-m (6.5-9.5 ft-lb)INOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs
11Using liberal amount of grease, assemble the shift cam stoppers; then install them into the top of the engineI NOTE: The