2004 Arctic Cat ATVs factory service and repair manual, Page 292Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 292

c AT THIS POINT 3Install the oil pump onto the engine; then tighten the Phillips-head screws securely After completing center
drive gear spacer onto the crank balancer shaftGrease the pin and insert it into the shaft: then install the drive sear making
sure the raised side of the gear is facing toward the insideSecure the gear with the cap screw (threads coated with red Loctite
#271) and the washerTighten the cap screw to kg-m (36 ft-lb) Install the secondary shaft bearing housing making sure the
two alignment pins are properly positionedTighten the Allen-head screws securely 5Grease the driven gear pin and insert it