2004 Arctic Cat ATVs factory service and repair manual, Page 293Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 293

I NOTE: When installed correctly, the sides of the drive and driven gears will be flush with each other 8Install the clutch
to 13 kg-m (94 ft-lb) Care must be taken that the directional washer be installed correctly and note that the nut has left-hand
threadsA CAUTION 1 When installed correctlvthe areen alignment dot (or the word OUTSIDE) the one-way clutch on 7Lightly grease
the clutch housing seal; then insert the left fixed drive spacer DOES NOT SHOW 11Place the clutch coverclutch housing assembly
into position on the crankcase; then secure with the cap screws making sure the different-lengthed cap screws are in their
proper locationTighten to 1.1 kg-m (8 ft-lb)12Place the air intake plate cushion into position; then install the air intake