2004 Arctic Cat ATVs factory service and repair manual, Page 294Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 294

16Place the V-belt into position on the driven pulley and over the front shaft 13Place the driven pulley assembly into position
nut (threads coated with red Loctite #271)Tighten the nut to 10.4-11.8 kg-m (75-85 ft-lb) 14Slide the fixed drive face onto
the shaft15Spread the faces of the driven pulley by pushing the inner face toward the engine while turning it counterclockwise;
then when the faces are separated, insert wedge (approximately 318 inthick) between the facesRelease the inner faceI NOTE: