2004 Arctic Cat ATVs factory service and repair manual, Page 295Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 295

19Place the V-belt cover gasket into position; then install the cover and secure with the cap screws making sure the different-lengthed
of the intermediate gear facing inward as noted in removing) 1Install the water pump drive gear alignment pin and the drive
gear (with the flat side of the gear facing outward as noted in removing); then secure with the snap ring 4In order on the
crankshaft, install washer, ring gear, key, and the magneto rotorSecure with the nut (threads coated with red Loctite #27
1)Tighten to 16 kg-m (116 ft-lb)5 Lubricate the magneto cover gasket with fresh engine oil; then place it into position on
the two dowel pins I NOTE: The sharp side of the snap ring should be facing outward 2Install the water pump driven gear alignment