2004 Arctic Cat ATVs factory service and repair manual, Page 297Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 297

Installing Top-Side Components APiston BCylinder KEY 1Cylinder 2Stud Bolt 3Nut 4Cylinder Gasket 5Pin 6Water Hose Union 7Cap
and lower thin oil rings according to the illustrationFront #ICompreSSiOn Ring End Gap #3 Thin #3 Thin Oil Ring Oil Ring
End Gap End Gap #2 Compression Ring End Gap and Oil Ring Expander End Gap 2Place the two alignment pins into positionPlace
the cylinder gasket into position; then place piston holder (or suitable substitute) beneath the piston skirt and square
the piston in respect to the crankcase I NOTE: Note the direction of the exhaust side of the piston (5) for correct ring
end gap orientation BInstall the compression rings (1 and 2) so the letter on the top surface of each ring faces the dome