2004 Arctic Cat ATVs factory service and repair manual, Page 299Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 299

7Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
the chain held tight, rotate the crankshaft until the piston is at top-dead-center12With the alignment pin installed in the
camshaft, loosely place the cam sprocket (with the recessed side facing the cam shaft lobes) onto the camshaftAt this point,
do not "seat" the sprocket onto the shaft 8Install the four cylinder head cap screws with copper washers (note the locations
of the different-lengthed cap screws)Tighten only until snug I NOTE: At this point, oil the camshaft bearings, cam lobes,