2004 Arctic Cat ATVs factory service and repair manual, Page 314Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 314

INOTE: Support the connecting rod with rubber bands to avoid damaging the rod or install the Connecting Rod Holder (pln 0444-006)
groove c AT THIS POINT To service piston, see Servicing Top-Side Components sub-section c AT THIS POINT To service center
crankcase components only, proceed to Removing Left-Side Components Left-Side Components I NOTE: For efficiency, it is preferable
to remove and disassemble only those components which need to be addressed and to service only those componentsThe technician
should use discretion and sound judgment 2.Remove the flange nut securing the starter cup to the crankshaft; then remove
the starter cupAccount for the O-ring inside the cup c AT THIS POINT To service any one specific component, only limited
disassembly of components may be necessaryNote the AT THIS POINT information in each sub-section I NOTE: The engineltransmission
does not have to be removed from the frame for this procedure 3Put the shift lever into the hi-range position and remove
the circlip from the hillow range shift shaft; then remove the shift leverI NOTE: It will be necessary to lift slightly on