2004 Arctic Cat ATVs factory service and repair manual, Page 321Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 321

I NOTE: When removing the right-side cover, account for the release roller guide that it does not fall and cause damage 8Remove
6Remove the water pump drive joint from the water pump shaftAccount for the pin CPrimary Clutch Shoe DPrimary Clutch EStarter
Clutch Housing I NOTE: Steps 1-6 in the preceding sub-section Remove the release roller assemblyAccount for four springsRemove
the starter clutch-shoe nut (left-hand threads) and washer from the driveshaft; then using primary clutch shoe remover, remove