2004 Arctic Cat ATVs factory service and repair manual, Page 329Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 329

2Place the valve cover on the Surface Plate (pn 0644-016) covered with #400 grit wet-or-dry sandpaperUsing light pressure,
must be used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result 3 Remove the valve
springs; then invert the cylinder head and remove the valves Removing Valves I NOTE: Keep all valves and valve components
as Measuring Valve Stem Runout a setNote the original location of each valve set for use during installationReturn each valve
set to its original location during installation 1Support each valve stem end with the Blocks (pln 0644-022); then check
the valve stem mnout using dial indicator 1Using valve spring compressor, compress the valve springs and remove the valve
cottersAccount for an upper spring retainer ATV-1082 2Maximum mnout must not exceed specifications Page: 329 Arctic Cat ATV