2004 Arctic Cat ATVs factory service and repair manual, Page 330Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 330

Measuring Valve Stem Outside Diameter 3Rotate the valve in the blocks 4Maximum mnout must not exceed specificationsMeasuring
then from top to bottom 2Acceptable width specifications 4Maximum "wobble" deflection must not exceed specificationsMeasuring
Valve Guide (Inside Diameter) 1Insert snap gauge 112 way down into each valve guide bore; then remove the gauge and measure
it with micrometer Measuring Valve Face Radial Runout 1Mount dial indicator on the surface plate; then place the valve stem
on set of blocks2Position the dial indicator contact point on the outside edge of the valve face; then zero the indicator
2Acceptable inside diameter range must be within specifications3If valve guide is out of tolerance, it must be replaced Replacing
Valve Guide IIf valve guide is worn or damaged, it must be replaced 1If valve guide needs replacing, insert valve guide remover