2004 Arctic Cat ATVs factory service and repair manual, Page 341Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 341

MEASURING SHIFT FORK (Thickness) I NOTE: Whenever shift fork is out of tolerance, replacement is necessary 1Using calipers,
the reel four turns counterclockwise; then release the rope from the notch and allow the rope to retract12Pull the rope out
two or three times to check for correct tensionIIncreasing the rotations in step 11 will increase spring tension 13Place
the recoil starter assembly into position on the left-side cover; then tighten the cap screws to 0.8 kg-m (6 ft-lb) 2Shift
fork groove width must be within specificationsMEASURING SHIFT FORK TO GROOVE (Side Clearance) 1In turn, insert each shift