2004 Arctic Cat ATVs factory service and repair manual, Page 346Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 346

CRANKSHAFT ASSEMBLY Measuring Connecting Rod (Small End Inside Diameter) 1Insert snap gauge into the upper connecting rod
platePosition the indicator contact point against the center of the connecting rod small end journal3Zero the indicator and
rotate the crankshaft slowly 2Zero the indicator and push the small end of the connecting rod away from the dial indicator
3Maximum deflection specifications should be taken to support the connecting rotating the crankshaft Measuring Connecting
Rod (Big End Side-to-Side) 1Push the lower end of the connecting rod to one 4Maximum mnout must not exceed specificationsI
NOTE: Proceed to check runout on the other end of the crankshaft by positioning the indicator contact at point and following
steps 2-4 side of the crankshaft journal 2Using feeler gauge, measure the gap between the connecting rod and crankshaft journal