2004 Arctic Cat ATVs factory service and repair manual, Page 359Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 359

10Install the two gear shift shafts; then verify that the two crankcase half alignment pins are in place 2Using plastic mallet,
case); then tighten only until snugIRotate the shafts back and forth to ensure no binding or sticking occurs Joining Crankcase
Halves 1Place the O-ring in the left-side crankcase half and verify that the washer is on the idler shaft; then apply Three
Bond Sealant (pln 0636-070) to the mating surfacesPlace the right-side half onto the left-side half 4From the right side,