2004 Arctic Cat ATVs factory service and repair manual, Page 360Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 360

8In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 5-6) to 0.9-1.3 kg-m (6.5-9.5 ft-lb)INOTE: Rotate
Pump BGear Shift Shaft 1Place the oil strainer with new O-ring into position beneath the crankcase and tighten securely with
the Phillips-head cap screws 6From the right side, install the five case half mm cap screws (one inside the case); then tighten
only until snugINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 2Place the strainer cap into
position on the strainer making sure the O-ring is properly installed and secure with the cap screws; then install and tighten
the oil drain plug to 2.2 kg-m (16 ft-lb) 7In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps 3-4)