2004 Arctic Cat ATVs factory service and repair manual, Page 363Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 363

13Place the primary drive one-way clutch into the starter clutch housing noting the word OUTSIDE for proper placement 17Secure
pattern, tighten the four cap screws securelyITighten the four roller assembly cap screws in crisscross pattern making sure
there is no clearance between the clutch plates when secured FWater Pump GOil Filter I NOTE: Steps 1-18 of the preceding
sub-sections must precede this procedureI NOTE: Lubricate all internal components with 10W-40 oil prior to installing the
right-side cover 16Install the clutch release arm and release roller guide making sure the release roller and guide are alignedPage:
363 Arctic Cat ATV 2004 -All Models 19Place the water pump drive joint into position on the water pump shaft making sure