2004 Arctic Cat ATVs factory service and repair manual, Page 369Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 369

24In crisscross pattern, tighten the cap screws (from step 22) to 0.9-1.3 kg-m (6.5-9.5 ft-lb) 25Place the shift stop housing
the subtransmission is in hi rangeIf not, shift into hi range26'lace the 'peedometer drive and gasket into position and secure
with the two cap screwsTighten securelyI 1 shaft gear match up during assembly Make sure the speedometer gear and output
pull up on the hillow shift dlethe T-handle stop pin into the hi range lever stop plate slot; then slide the shift lever
assembly the rest of the way onto the shift shaftSecure with the outer circliwmaking sure the sharp side of the circliw facesaway