2004 Arctic Cat ATVs factory service and repair manual, Page 371Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 371

2Place the two alignment pins into positionPlace the cylinder gasket into position; then place piston holder (or suitable
wall of the cylinder; then using ring compressor or the fingers, compress the rings and slide the cylinder over the pistonRoute
the cam chain up through the cylinder cam chain housing; then remove the piston holder and seat the cylinder firmly on the
crankcase 5Install the coolant hose onto the crankcase union and tighten the clamp The cylinder should slide on easilyDo