2004 Arctic Cat ATVs factory service and repair manual, Page 373Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 373

9Loosely install the five cylinder head nuts I NOTE: At this point, oil the camshaft bearings, cam lobes, and the three seating
step 9) to 2.5 kg-m (18 ft-lb)Using crisscross pattern, tighten the four mm nuts (from step 9) to 1.1 kg-m (8 ft-lb)Tighten
the two cylinder-tocrankcase nuts securely11With the timing inspection plug removed and the chain held tight, rotate the
crankshaft until the piston is at top-dead-center12With the alignment pin installed in the camshaft, loosely place the cam
sprocket (with the recessed side facing the cam shaft lobes) onto the camshaftAt this point, do not "seat" the sprocket onto
the shaft 14Seat the cam sprocket onto the camshaft making sure the alignment pin in the camshaft aligns with the smallest
hole in the sprocket; then place the camshaftlsprocket assembly onto the cylinder ensuring the following Page: 373 Arctic