2004 Arctic Cat ATVs factory service and repair manual, Page 379Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 379

16Place the exhaust pipe into position inside the frame and connect to the muffler at the junctureI NOTE: If the muffler
in removing; then place the fuse block into position and secure with two screwsIIf the mounting screw holes have elongated,
it will be necessary to install larger diameter screwsBSecure the upper end of the reverse shift rod to the shift lever arm
with new lock nutTighten securely It is critical that all wiring be installed correctly to ensure electrical components will
function properly 23Pour the correct amount of recommended oil into the engineltransmissionfiller hole; install the filler
15Place the footrests into position on the frameTighten the 10 mm cap screws to 5.5 kg-m (40 ft-lb) and the mm cap screws
to 2.8 kg-m (20 ft-lb); then secure the fender extensions to the footrests with existing hardware 24Pour 2.9 (3 U.Sqt) of
premixed Arctic Cat Antifreeze (pln 0638-395) into the cooling systemAllow coolant to settle and then fill to the bottom