2004 Arctic Cat ATVs factory service and repair manual, Page 387Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 387

I NOTE: Check float arm height by placing the carburetor on its side wlfloat contacting the needle; then measure with caliper
the groove in the carburetorIf the diaphragm is not properly seated, leakage will occur 8Place the jet needle, spring seat,
and spring into the vacuum piston; then place the assembly down into the carburetor 7Place the U-ring into the primer housingPosition
the spring and diaphragm assembly (lip toward the carburetor) onto the carburetor; then secure the assembly with the primer