2004 Arctic Cat ATVs factory service and repair manual, Page 394Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 394

CEY Oil Pump 2Drive Gear 3Pin 4Washer 5Circlip 6Cap Screw 7Strainer 8Cap Screw 9Cap 100-Ring ICap Screw 12Filter 13Drain
of the pump and separate the pump housing and coverNote the position of the inner and outer rotors and alignment pin for
assembly3Remove oil pump componentsCLEANING AND INSPECTING W NOTE: Whenever part is worn excessively, cracked, or damaged
in any way, replacement is necessary OIL PRESSURE suuu0.6-1kgcm2 (9-14 psi) Oil Temerature 60 (140F 1Clean all oil-pump components
2Inspect the rotors for scoring and gouges3Inspect the alignment pin for damage4Inspect the pump housing and cover for cracks
or damage OIL PRESSURE w I Place the rotors into the pump housing making sure the alignment pin is in the groove of the rotor
2Place the cover onto the pump housing3Secure the pump with the Phillips-head screw coated with red Loctite #27 1 OIL PRESSURE