2004 Arctic Cat ATVs factory service and repair manual, Page 399Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 399

CLEANING AND INSPECTING Servicing Water Pump - Manual Transmission) W NOTE: Whenever part is worn excessively, cracked, or
screw securely3Place the water pump case into position and secure with the three cap screwsNote the position of the long
cap screw fiom removal2Remove the three cap screws securing the water pump caseNote the position of the long cap screw and
account for the O-ring3Remove the impeller cap screw, washer, and gasket 4Fill the cooling system (2.9 or qt) with antifreezeW
NOTE: While the cooling system is being filled, air pockets may develop; therefore, run the engine for five minutes after
the initial fill, shut the engine off, and then fill the cooling system 4Remove the mechanical seal using this procedureATap
the tip of small sheet metal screw into the inner-metal edge of the seal BGrip the screw wlth pair of vise-grip pliers and