2004 Arctic Cat ATVs factory service and repair manual, Page 402Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 402

2Place the new mechanical seal into the bearing housing; then tap it down until it is fklly seatedW NOTE: large deep-well
securely 5With the bearing housing assembly in position on the engine7place the cover (with O-ring installed) into position
on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING 1Secure the water pump to the engine
with the two cap screws tightened securely; then tighten the two Phillips-head cap screws securelyCC788A 4Place the footrest
into position on the frame and loosely secure with four cap screws; then secure the front and rear fenders to the footrest
with the four tom-head cap screwsTighten the four tom-head cap screws securely; then tighten the two mm cap screws to 2.8
kg-m (20 ft-lb) and the two 10 mm cap screws to 5.5 kg-m (40 ft-lb)5Fill the engineltransmission with the proper amount of
recommended oilcc786 6Fill the cooling system with the proper amount of recommended coolant Page: 402 Arctic Cat ATV 2004