2004 Arctic Cat ATVs factory service and repair manual, Page 407Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 407

Battery 6Place the battery into position in the ATV and secure; then connect the vent hose to the battery 7Connect cables
cable R Limiter The ATV has an RPM limiter system to limit the engine RPMOne way to eliminate the activation of the RPM limiter
is to utilize the throttle limiter screw at the throttle leverI NOTE: The ATV is equipped with CDI unit that retards ignition
timing when maximum RPM is approachedWhen the RPM limiter is activated, it could be misinterpreted as high-speed misfire
Do not charge the battery while it is in the ATV with the battery terminals connected 2Remove the vent plugs; then fill the
battery with electrolyte to the UPPER level indicated on the batteryI NOTE: Electrolyte should be at room temperature before
fillingDo not use water or any other liquid to activate battery 1Ensure that the throttle cable is adiusted correctly at
3-6 mm (118-114 in free-play atthe leverJam Nut Adjuster Electrolyte is sulfuric acid solutionAvoid spillage and contact