2004 Arctic Cat ATVs factory service and repair manual, Page 412Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 412

Remove all fuses from the fuse blockSet the meter selector to the D.CVoltage positionConnect the black tester lead to groundUsing
2501300, the ignition coil is attached to the upper frame behind the right-hand side panelTo access the coil, the seat and
right-hand side panel must be removed (see Section 8)On the 4001500, the ignition coil is on top of the engineTo access the
coil, the seat and gas tank (see Section 4) must be removedVOLTAGE (Primary Side) INOTE: The ignition switch must be in the
ON position; the emergency stop switch must be in the RUN positionAlso, the whitelblue wire must be disconnected from the
coil 1Set the meter selector to the D.CVoltage position2Connect the black tester lead to the whiteblue wire; then connect
the red tester lead to groundAlways disconnect the battery when performing resistance tests to avoid damaging the1 multimeter
3The meter must show IV 204With the tester leads connected, depress the starter button5 The meter must show 130V 20I NOTE: