2004 Arctic Cat ATVs factory service and repair manual, Page 415Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 415

3The temperature warning indicator light should illuminateNEUTRAL POSITION LIGHT I NOTE: The meter may show less than 12
LIGHT VOLTAGE (500) Connect the jumper positive wire to the power source terminal on the indicator light connectorConnect
the jumper ground wire to the reverse terminal on the indicator light connectorThe reverse position indicator light should
illuminateBEAM LIGHT Connect the jumper positive wire to the high beam terminal on the indicator light connectorConnect the
jumper ground wire to the female terminal on the indicator light connectorThe HI beam indicator light should illuminateI
NOTE: If light fails to illuminate in any one of the indicator light tests, the connector, wiring harness, or bulb must be
replaced INOTE: The ignition switch must be in the ON position, and the test must be performed on the lower side of the switch
Set the meter selector to the D.CVoltage positionRemove the violet water temperature switch wire connector from the switch
(on the left side of the engine below the water hose) and ground it to the engineConnect the red tester lead to the redhlack