2004 Arctic Cat ATVs factory service and repair manual, Page 416Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 416

2Connect the red tester lead to the redlblack wire; then connect the black tester lead to the blue wire To replace speed
the Allen-head mounting screw and separate the sensor from the housing 2Connect the red tester lead to the Vcc pin; then
connect the black tester lead to the pin3Install the new speed sensor into the housing with new O-ring lightly coated with
multi-purpose grease; then secure the sensor with the Allen-head mounting screw (threads coated with blue Loctite #242)Tighten
securely 3The meter must show 37-38 k-ohms 4With the black tester lead connected to the pin, connect the red tester lead
to the pin5The meter must show ohmsIIf the sensor tests are within specifications, the speedometer must be replacedSee Section
95-12 Page: 416 Arctic Cat ATV 2004 -All Models 4Place the sensor housing in position on the crankcase making sure the gasket