2004 Arctic Cat ATVs factory service and repair manual, Page 417Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 417

7The meter must show less than ohm8Connect the red tester lead to the red wire; then connect the black tester lead to the
selector to the D.CVoltage position 2Connect the red meter lead to the red wire; then connect the black meter lead to ground:Always
disconnect the battery when performing resistance tests to avoid damaging the1 multimeter 3Meter must show battery voltageINOTE:
If the meter shows no battery voltage, troubleshoot the battery or the main wiring harness RESISTANCE (HI Beam) 1Set the
meter selector to the OHMS position RESISTANCE Always disconnect the battery when performing resistance tests to avoid damaging
the multimeter 2Connect the red tester lead to the yellow wire; then connect the black tester lead to the gray wire 3With
the dimmer switch in the HI position, the meter must show less than ohmI NOTE: If the meter shows more than ohm of resistance,
troubleshoot replace the switchcomonent, the connector, or the switch wiring harness I NOTE: Perform this test on the upper