2004 Arctic Cat ATVs factory service and repair manual, Page 418Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 418

RESISTANCE (Starter Button) 1Set the meter selector to the Diode position2Connect the red tester lead to the orangelwhite
(see Section 8)I NOTE: Resistance tests should be made with the connector disconnected and on the selector-side of the connector
RESISTANCE (Emergency Stop) RESISTANCE 1Set the meter selector to the OHMS position2Connect the red tester lead to the orange
wire; then connect the black tester lead to the orangelwhite wire3With the switch in the OFF position, the meter must show
an open circuit Always disconnect the battery when resistance tests to avoid damaging multimeter 1Set the meter selector
to the OHMS position2Connect the red tester lead to the red wire; then connect the black tester lead to the white wire3With
the selector switch in the 2WD position, the meter must show closed circuit 4With the switch in the RUN position, the meter
must show less than ohmIIf the meter shows more than ohm of resistance, troubleshoot or replace the switchcomponent, the
connector, or the switch wiring harnessRESISTANCE (Reverse Override) 4With the selector switch in the 4WD position, the meter