2004 Arctic Cat ATVs factory service and repair manual, Page 419Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 419

Front Drive Selector Actuator (400 FIS500) 3With the engine running at constant 5000 RPM (with the headlights on), the meter
to the whitelred wire in the supply harnessThe meter must show 12 D.CvoltsSelect the 4WD position on the front drive selector
switch; then connect the red tester lead to the whitelred wire in the supply harnessThe meter must show D.CvoltsConnect the
red tester lead to the orange wire in the supply harnessThe meter must show 12 D.CvoltsI NOTE: If the voltage readings are
as specified and the actuator does not function correctly, replace the actuator (see Section 6) The connector is the black
and white one on the right side of the engine just above the brake cable adjusterINOTE: Test the connector that comes from
the engine 1Set the meter selector to the A.CVoltage position2Test between the three yellow wires (2501300) for total of
three tests or the three black wires (4001500) for total ofthree tests 3With the engine running at constant 5000 RPM, all