2004 Arctic Cat ATVs factory service and repair manual, Page 420Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 420

2Test between the three yellow wires (2501300) for total of three tests or the three black wires (4001500) for total of three
Model 73 Multimeter (pin 0644-191) with Peak Voltage Reading Adapter (pin 0644-307)If any other type of tester is used, readings
may vary due to internal circuitry 2On the 2501300, connect the red tester lead to the blacklyellow wire; then connect the
black tester lead to the greenlwhite wireThe meter reading must be within specification3On the 4001500, connect the red tester
lead to the green wire; then connect the black tester lead to the blue wireThe meter reading must be within specificationRESISTANCE
(Source Coil 4001500) INOTE: The battery must be at full charge for these testsMagneto Coil (Trigger) 1Set the meter selector
to the D.CVoltage position 2Connect the red tester lead to the green wire; then connect the black tester lead to the blue
wire3Crank the engine over using the electric starter4The meter reading must be within specificationMagneto Coil (Source)