2004 Arctic Cat ATVs factory service and repair manual, Page 422Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 422

11Remove the positive brush assembly from the starter housing 9Bend the two positive brushes outward; then remove the brush
measure the length ofthe brushesIf brush measurement is less than 10.1 mm (0.40 in, replace with new brushes and brush springs
as set4Inspect the brush leads for cracks, wear, or frayingIf any of these conditions exist, replace with new brushes and
brush springs as set5Inspect the rear cover bushing for wear 10Remove the nut from the positive postAccount for the lock
washer, flat washer, fiber washer, and an O-ring 6Inspect the front cover bearing for wear7Inspect the brass commutator end
of the armature for any burned spots or damageIf the commutator is lightly burned or damaged, the armature must be replacedThis