2004 Arctic Cat ATVs factory service and repair manual, Page 423Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 423

8Inspect the commutator end of the armature for buildup in the groovesCarefully remove any buildup by undercutting using
arc between individual sections of the commutator 10Inspect the commutator for shorting using multimeter and the following
procedure Armature Brush Holder Set Brush Terminal Set 0-Ring Washer Set Spring 7Front Bracket Assy 8Bolt Set 9101112 ASet
the selector to the OHMS position BTouch the black lead to the armature shaftCUsing the red tester lead, probe the commutator
end of the armatureThe meter indicator should not changeIf the indicator shows resistance, the armature is shorted and must
be replaced11Inspect the armature for shorting using "growler" and the following procedure11 0-Ring 0-Ring Nut Cap Screw
APlace the armature in the "growler BWhile holding metal strip on the armature, rotate the armature an entire revolutionIf
the metal strip vibrates at any point on the armature, the armature is shorted and must be replacedKEY 1Starter Motor Assy