2004 Arctic Cat ATVs factory service and repair manual, Page 425Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 425

8Place the front cover onto the starter housing making sure it seats properly9Apply red Loctite #27 to the threads of the
amount of grease to the front cover bearing and seal; then install the seal protector Perform this test on the starter motor
positive terminalTo access the terminal, slide the boot awayIThe ignition switch must be in the ON position, the emergency
stop switch in the RUN position, the reverse lever (on manual transmission models) in the FORWARD position, and the shift
lever (on automatic transmission models) in the NEUTRAL position 1Set the meter selector to the D.CVoltage position2Connect