2004 Arctic Cat ATVs factory service and repair manual, Page 426Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 426

I NOTE: If the meter showed battery voltage but the starter did not operate or operated slowly, inspect battery voltage (at
is goodDisconnect all wires from the solenoid2Set the meter selector to the OHMS position3Connect the tester leads to each
of the heavy posts of the solenoid4The meter must show an open circuit 6With the 12-volt power supply still connected, connect
the red tester lead to the heavy battery cable terminal; then connect the black tester lead to the heavy starter motor cable
terminal 7The meter must show less than ohm 8With the 12-volt power supply disconnected, connect the tester leads to each
small terminal of the solenoid9The meter must show 4.3 ohms 20INOTE: If the meter shows no resistance, the relay is out of
tolerance or it must be replaced Starter Relay I NOTE: Leave the tester leads connected to the solenoid posts for the following
procedure INOTE: An external 12-volt power supply "jumper" (positive and negative connections) must be used for this testAlso,