2004 Arctic Cat ATVs factory service and repair manual, Page 427Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 427

RESISTANCE CDI Unit Always disconnect the battery when performing resistance tests to avoid damaging the1 multimeter 1Disconnect
from the CDI connector to the CDI unit I NOTE: An external 12-volt power supply "jumper" (positive and negative connections)
must be used for this testAlso, it is very important that the meter leads and power supply connections are made to the appropriate
terminals of the relay or damage to the multimeter will result 5Connect the power supply (positive) to terminal #3; then
connect the power supply (negative) to terminal #4There should be an audible "click" from the relay, and the meter must show
less than ohmINOTE: If there was no audible "click from the relay or if the meter shows more than ohm, it must be replacedIf
there was "click," continue to test resistance RegulatorRectifier (2501300) The regulatorlrectifier is located near the batteryRESISTANCE
A CAUTION Always disconnect the battery when performing resistance tests to avoid damaging the -multimeter1 6With the 12-volt