2004 Arctic Cat ATVs factory service and repair manual, Page 429Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 429

Neutral Start Relay (400 ACT) 2Connect the power supply (positive) to one copper terminal; then connect the power supply
connect the red tester lead to the yellowlgreen wire5Depress the starter buttonThe meter must show battery voltageI NOTE:
If the meter shows no battery voltage, inspect fuses, wiring harness, connectors, and switches 4With the power supply still
connected, connect the red tester lead to one brass terminal; then connect the black tester lead to the other brass terminal5The
meter must show less than ohmINOTE: If the meter shows more than ohm (even thouah the "click" was heard in the Dower supply
test), the relay must be replacedRESISTANCE (Relay Copper Terminals) RESISTANCE (Relay Brass Terminals) Always disconnect
the battery when performing resistance tests to avoid damaging the multimeterINOTE: The external power supply will not be
used for this test ACAUTION Always disconnect the battery when performing resistance tests to avoid damaging multimeterINOTE: