2004 Arctic Cat ATVs factory service and repair manual, Page 430Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 430

Neutral Start Start-in-Gear Relays (400 FIS500) 4With the dimmer switch in the HI position, test the two outside connectors
bumper supports (one on each side) with cable tiesBULB VERIFICATION (Low and High Beam) Connect the power supply (positive)
to the yellow wire; then connect the power supply (negative) to the brown wireThe taillight should illuminateWith the negative
power supply still connected, connect the positive supply wire to the red wireThe brakelight should illuminateI NOTE: If
either the taillight or brakelight fails to illuminate, inspect the bulb, the connectors, or the component wiring harness
Also, 12-volt external power supply wljumpers will be needed I NOTE: Perform this test on each headlight bulb 1Disconnect
the wiring harness from the bulb to be tested2Connect the power supply (positive) to one bulb contact; then connect the power
supply (negative) to the remaining bulb contact VOLTAGE (Taillight) INOTE: Perform this test on the main harness side of
the connectorAlso, the ignition switch should be in the LIGHTS position 3The bulb should illuminate4If the bulb fails to