2004 Arctic Cat ATVs factory service and repair manual, Page 451Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 451

3Install the input shaft into the housing; then install the front boot and secure with Boot Clamp (pln 0423-393) and the
it is flush with the edge of the housing4Place the input shaft assembly onto the gear housing; then secure with the existing
cap screwsTighten to 2.9-3.5 kg-m (2 1-25 ft-lb)IIf new gear housing is being installed, tighten the cap screws to 3.5-4.3