2004 Arctic Cat ATVs factory service and repair manual, Page 457Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 457

Removing Needle Bearing I NOTE: Removing the needle bearing is rarely necessaryAvoid removing the needle bearing unless the
then drill through the pinion shaft needle bearing housingCC888 2Using suitable driver, install the needle bearing into the
housing making sure the bearing is seatedINOTE: Do not push the bearing too far into the housing 2Using propane torch, heat
the area surrounding the needle bearing to approximately 300' 3Install the pinion shaft and secure with the existing 48 mm
nutTighten to 17.3 kg-m (125 ft-lb) 3Using flat-nosed punch, drive the bearing out of the housing 4Place punch on the edge